KERN & Sohn GmbH Ziegelei 1 D-72336 Balingen E-Mail: [email protected] Tel: +49-[0]7433- 9933-0 Fax: +49-[0]7433-9933-149 Internet: www.kern-so
6 Operation 6.1 Overview of the keypad Key Pressed briefly Pressed for 10 sec Switching the balance on Tara-Function Unit changing Switc
After removal of the tare cup the total weight appears as a negative value with „-„ mark. 6.2.3 Units Different foreign weighing units are integrat
Press the ON/TAREkey to switch among the settings: Display Mode „tr“ ON Auto-Zero on „tr“ OFF Auto-Zero off Confirm with . Wait until the b
6.2.6 Reset function Factory setting reset. When the balance is switched off, press and keep it pressed Do not release . Press also the -ke
7 Maintenance, upkeep, disposal 7.1 Cleaning Please disconnect the device from the operating voltage before cleaning. Only use a cloth dampened wi
8 Troubleshooting The balance should be switched off for a short time following an interruption in the programme sequence and disconnected from the
9 Declaration of Conformity KERN & Sohn GmbH D-72322 Balingen-Frommern Postfach 4052 E-Mail: [email protected] Tel: 0049-[0]7433- 9933-0 Fax: 00
GB KERN EMB 500-1GN Version 1.0 05/2014 Operating Instructions Precision balance Table of contents: 1 Technical data ...
1 Technical data KERN EMB 500-1GN Readout (d) 0,1 g Weighing range (Max) 500 g Reproducibility 0,1 g Linearity ± 0,2 g Adjusting weight (not inc
2 Fundamental information (general) 2.1 Intended use The balance you have acquired serves to determine the weighing value of the mate-rial to be we
3 Fundamental safety information 3.1 Observe the information in the operating instructions Carefully read this operation manual before setup and c
5 Unpacking, installation and commissioning 5.1 Place of installation, place of use The balance is constructed in such a way that reliable weighing
5.2 Unpacking Carefully remove the balance from its packaging, remove the plastic wrapping and position the balance in its intended working location.
5.6 Adjustment As the acceleration value due to gravity is not the same at every location on earth, each balance must be coordinated – in compliance
1 2 5.7 Underfloor weighing Objects which, because of their size or shape, cannot be put on the scale, can be weighed by means of underfloor weighing
Commentaires sur ces manuels